Match PP 62DSP User Manual page 24

Installation
Fig. 4 MATCH cable harness – switching of constant plus and switched plus terminal
1
2
ISO female connector of the MATCH cable harness
1
ISO male connector of the MATCH cable harness
2
Yellow wire – ex works connected to the power supply cable of the amplifier
E
Blue wire – ex works left open
F
+12 Volts power wire of the amplifier – make sure that this is connected to constant
G
plus terminal of your car.
Fig. 5 Possibility for direct power supply from the battery
This side of the cable harness will be directly connected to the car's battery. Therefore
4
you have to separate the cable joints I and H.
After separating the joints I and H the unused open wire ends have to be properly
5
insulated with tape or other appropriate material.
The +12 Volts wire has to be connected to the positive terminal of the car's battery.
I
The ground wire has either to be connected to the negative terminal of the battery or
H
directly to the car's chassis.
24
F
E
I
4
H
G
5