Cooling Fan - Panasonic AK-HC1800N Operating Instructions Manual

Major operating controls and their functions
 HD SDI output connector [HD SDI OUT]
HD SDI signal output is given by this line.
 G/L input connector [G/L IN]
For gen-lock with the camera, the external sync signal (black burst) or tri-level sync
signal is supplied to this input connector.
 Operate indicator
Green LED lamp lights to indicate that the specified DC 12 V power is supplied to the
interface connector .
 Cooling fan
• Do not block or obstruct the ventilation during operation. It may otherwise cause
internal heating or fire.
• The life of this fan is approximately 0,000 hours (at room temp. 77 °F (25 °C)).
Replace the fan as needed.
(When the room temperature is higher than 95 °F (5 °C), replace the fan 0 %
earlier.)
Be sure to ask the dealer for the replacement.
 Interface connector [I/F]
Pin No.
When supplying DC power, supply the DC +12 V voltage to pin 6 and connect GND to
pin 8.
1 Gen-lock signal GND
2

 TX_N (EIA22)/TXD (EIA22) output
5 RX_N (EIA22)/RXD (EIA22) input
6 DC power supply input (+12 V)
7 Gen-lock signal input
8
9 TX_P (EIA22) output
10 RX_P (EIA22) input
11
12
1
1
15
Signal
Not used
Not used
DC GND
GND
Not used
GND
GND
GND
- 10 -