Advertisement
F
eatures and benefits
Indications and functions
Special purpose
Dial pre-selection
The second
The first
digit
digit
0
0
0 - 9
A
The second
The first
digit
digit
0
0
B
Select any of
0 - 9
The second
The first
digit
digit
0
0
C
Select any of
0 - 9
The second
The first
digit
digit
0
0
0 - 9
D
The second
The first
digit
digit
0
0
E
Select any of
0 - 9
The second
The first
digit
digit
0
0
F
Select 0 and 1
Mode of reverse switch
Clockwise rotation
If the dial of second digit is set on "A", the machine does not
start in spite of pulling trigger switch, or setting the dial of
first digit on any numbers.
The machine stops after the
sensor perceives the first blow,
depending on the pre-selected
figures of the first digit.
For instance,
0 : Stop at one
1 : Stop 0.1 sec. later
2 : Stop 0.2 sec. later
9 : Stop 0.9 sec. later
The machine starts or stops
with operation of the trigger
switch.
If the dial of second digit is set on "D", the machine does not
start in spite of pulling trigger switch, or setting the dial of
first digit on any numbers.
The machine does not start in
spite of pulling trigger switch,
0.2 sec. depending
but buzzers
on the pre-selected figure of
the first digit after pulling
trigger switch, . For instance,
0 : one time buzzer
1 : two times buzzer
2 : three times buzzer
9 : ten times buzzer
If the dial of second digit is set on "F" and the same of the first
digit is set on zero or one, the following matters are informed.
0 : information of the version code of program
* Version code 2.1 : two long buzzers - long pause,
- one short buzzer
* Version code 3.2 : three long buzzers - long pause,
- two short buzzers
1 : information of the remaining voltage as follows.
* 23 V : two long buzzers - long pause - three short buzzers
* 20 V : two long buzzers
* 18 V : one long buzzer - long pause - eight short buzzers
* 9 V : nine short buzzers
Anti-clockwise rotation
The machine starts or stops
with operation of the trigger
switch.
The machine stops after
stopping its blow, depending
on the pre-selected figures
of the first digit. For instance,
0 : Stop at one
1 : Stop 0.1 sec. later
2 : Stop 0.2 sec. later
9 : Stop 0.9 sec. later
The machine starts, and stops
depending on the pre-selected
figure of the first digit after the
sensor perceives how many
times you have hit the housing,
For instance,
0 : stop with one time hitting
1 : stop with two times hitting
2 : stop with three times hitting
9 : stop with ten times hitting
P 4 / 9
Purpose
Preliminary fastening
of bolts
Loosening of bolts
Checking the functions
mentioned below.
For instance
* BPM. pre-select dial
* Stop of motor
* Buzzer
Checking the version
code of program in the
controller
and
remaining voltage of
battery
Advertisement
