Zanussi ZDM17301WA User Manual page 14

Code
E3
E4
INSTALLATION
ASSEMBLY
Make sure to position the appliance
with minimum space of 50mm on both
sides of fully open door.
Keep 5 mm distance between both sides of the
appliance and the cabinet. There are two
possibilities for the cabinet hole for the appliance.
100
min.
550 mm
Power cord, drain hose and water supply line
1
hole. To facilitate a proper installation, position
the hole to the right or the the left of the
appliance.
ELECTRICAL CONNECTION
WARNING! Do not use an extension
cord or and adapter plug with this
appliance.
WARNING! Do not cut or remove the
earthing.
14
Required temperature is not
reached.
Overfilled.
min.
80
443mm
min.
555mm
Meaning
WARNING! Make the electrical
connection with the power cord.
For rating voltage check the rating
plate.
WATER DRAIN CONNECTION
• Connect the water drain hose into a drain pipe
with minimum diameter of 40 mm.
• Put the water drain hose directly into the sink.
use the special plastic support.
The water drain hose must be less than 750 mm
from the bottom of the appliance to prevent
problems during the draining phases.
Remove the sink plug when the appliance drains
water to prevent that the water goes back into the
appliance.
The extension of the water drain hose must not be
longer than 2 m. The internal diameter must not be
smaller than the diameter of the drain hose.
If you connect the water drain hose to a trap spigot
under the sink, remove the plastic membrane (A). If
Possible cause
Malfunction of heating element.
Too much inlet water or some
dishwasher element leaks.
max. 750 mm