Table of Contents
Advertisement
Alignment and Adjustments
< Service Method >
❈ After replacing it with a new DMD board, tighten screw spring #3
using weak power (below 8kgf).
Then, lightly tighten screws #1 and #2 without tightening them
completely.
1-42
Remove the two screws on the left and the one screw
on the bottom right, without removing the engine.
❈ When those screws are removed, the board will
not separate. It can be moved within the adjustable
range because there are spring screws in the
center area which hold it.
Remove the three spring
screws at the center area
completely.
Samsung Electronics
Hide quick links:
Advertisement
Table of Contents
