ViewSonic VS11661 Service Manual page 37

Auto Color (Automatically calibrate chip ADC parameter by using chip internal DAC)
If it is a new-built set and it is first time to do the "auto color", please confirm the following steps:
-Connect the VGA cable with the standard video pattern generator and display 5-mosic pattern on the monitor.
- Press "Power" to power off the monitor.
- Press"
- Press ''Menu[1]'', then press ''Auto[2]'' to execute Auto color item.
- After the "Auto Color" process finished, please press "Power" to restart monitor.
EDID (Rewrite EDID data to EEPROM)
If we need to rewrite the EEPROM data, please confirm the following steps.
1. Plug in VGA Cable; we can rewrite the EDID data to EEPROM by using "EDID Rewrite" program.
2. If the "EDID Rewrite" process finished, please pull out VGA cable and press ''2''+''▲'' at the same time.
3. Pull out AC power cable or press power key to restart.
Upload firmware to MCU via VGA Cable
5.7.1 Connect ISP board between monitor and PC as below configure
5.7.2 Using mStar ISP Tool Update FW:
(1). Seletct "Read", Choose the corresponding firmware, load to MCU.
(2). Select "Connect", auto connect for ISP.
ViewSonic Corporation
Downloaded from www.Manualslib.com
[▼] +[▲] + [ ]
"simultaneously to enter factory mode.
Insert to Print
Port 25pin
manuals search engine
Service
cable
ISP Board
34
Confidential - Do Not Copy
LCD Monitor
D-Sub
VX2255wmh-4
VX2255wmb-4