ViewSonic VS11661 Service Manual page 15

"On" when power is restored after a power failure. If the power button is not in the locked mode, then power should
return to it's previous state when power is restored after a power failure.
The power button lock will be deactivated by pressing the front panel control buttons "(1), & (▼)" again for 10
seconds.
Note 1: Status bar indicating Power Button lock or unlock is in progress and when complete it will indicate "Power
Button Locked"
Note 2: Power should only be lockable in the "On State"
Memory Recall Actions
Memory Recall action on the analog and digital mode as below
1. Set the factory defaults as shown in Section 2-8
2. Clean all the mode setting buffer
3. Execute Auto Image Adjust
Note: Memory Recall should have no effect for Language, Power Lock, User Color Settings or Input Priority
Resolution Notice Actions
Resolution Notice OSD should show on screen after changing to non-native mode for 30 sec
The OSD should disappear after 10 sec or by pushing button [1] or [2]
Resolution Notice function should be disabled when push button [2] under Resolution Notice OSD
0-Touch™ Function Actions
1. Execute Auto Image Adjust when new mode detected, and save the settings to buffer for further use
2. It should be reset by Memory Recall function
(Should not reset by power off, power unplug and others)
OSD Auto Save
The OSD shall save new settings when it is turned off by the user or when it times out. There shall not be a
separate save
Input Priority
This function is defined the auto detect priority when the display has several inputs. Please refer to the detail flow
chart as the appendix D
ViewSonic Corporation
Downloaded from www.Manualslib.com manuals search engine
12
Confidential - Do Not Copy
VX2255wmh-4
VX2255wmb-4