Table of Contents
Advertisement
Installing the hob
Do not trap cables during installation. Push the hob in until it
locks into place.
Worktop cut-out, 500 mm deep:
Mark the centre of the cut-out
1.
Put the hob in place
2.
Align the markings on the hob surround and cut-out
3.
Press in the hob.
4.
Connecting the hob
The cooker or control unit should be connected to the mains,
but switched off.
Insert the cooker until the socket is accessible.
1.
Screw the PE conductor (green/yellow) for the hob to the
2.
earthing point of the cooker.
Plug in the hotplate connector on the cooker. The colour of
3.
the cable should agree with the colour shown on the label.
The lug N on the plug must point to the left.
Slide the cooker back in. Do not trap the cable while doing this.
Note: Seal the tile joints on tiled work surfaces with silicone
rubber.
Removing the appliance
Disconnect the appliance from the power supply. Pull out the
cooker a short distance. Pull out the hob connector. Finally
remove the earthing conductor. Push out the hob from below.
6
1
<
7
Advertisement
Table of Contents
