Panasonic HX-DC2 Operating Instructions Manual page 74

When Ø2 (2sec) is selected
When you press the
status indicator flashes red for approximately 2 seconds, then recording
begins.
On the LCD monitor, an indication of (
to notify you of the recording timing.
When Ø10 (10sec) is selected
When you press the
status indicator flashes red for approximately 10 seconds, then recording
begins.
On the LCD monitor, an indication of (
#
recording timing.
≥ After the recording, the self-timer setting is cancelled.
To stop the timer midway through
Press the button or the recording start/stop button.
≥ Setting the self-timer to Ø2 or Ø10 is a good way to prevent image
shake when the
≥ If you register a shortcut function (l 79) to the SET button, you can
change the self-timer setting from the recording screen.
≥ If you set [FOCUS] (l 87) to
recording still pictures, the unit will focus automatically immediately
before recording.
≥ With motion picture recording/audio recording, recording does not turn
off automatically.
≥ If you perform any of the following cases, the self-timer will be
cancelled.
j If you turn the unit off
j If you change to the playback mode
j If you send unit into standby mode by closing the LCD monitor
j When it goes into sleep mode
[FOCUS]
Please refer to page 87.
74
VQT4D23
button or the recording start/stop button, the
button or the recording start/stop button, the
#
) appears to notify you of the
button is pressed while using a tripod etc.
(AUTO) or
#
) appears
# #
(MACRO) when