Installation - AEG AGN58210F0 User Manual

INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
POSITIONING
This appliance can be installed in a dry,
well ventilated indoor (garage or cellar) al-
so, but for optimum performance install
this appliance at a location where the am-
bient temperature corresponds to the cli-
mate class indicated on the rating plate of
the appliance:
Cli-
mate
class
SN
N
ST
T
ELECTRICAL CONNECTION
CAUTION!
Any electrical work required to in-
stall this appliance should be car-
ried out by a qualified electrician
or competent person.
WARNING!
This appliance must be earthed.
The manufacturer declines any lia-
bility should these safety meas-
ures not be observed.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
A
E
The wires in the mains lead are
coloured in accordance with the
following code:
A Green and Yellow:
C Brown:
E Blue:
As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals in your plug, proceed as follows:
1. Connect the wire coloured green and
yellow to the terminal marked either
with the letter "E" or by the earth
symbol or coloured green and yel-
low.
2. Connect the wire coloured blue to
the terminal either marked with the
letter "N" or coloured black.
3. Connect the wire coloured brown to
the terminal either marked with the
"L" or coloured red.
4. Check that no cut, or stray strands of
wire is present and the cord clamp D
is secure over the outer sheath.
5. Make sure the electricity supply volt-
age is the same as that indicated on
the appliance rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp
plug fitted B. In the event of having to
change the fuse in the plug supplied, a 13
17
B
C
D
Earth
Live
Neutral