Assembly - Electrolux Z4680 SERIES Owner's Manual

HOW TO MAINTAIN
The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the cyclonic
dust cup, belt, and brush roll often.
To Change Dust Cup Pleated Filter:
NOTE: Turn off the switch and unplug the electrical cord before changing the pleated filter. Never operate the vacuum
cleaner without the dust cup or the pleated filter assembly.
Remove dust cup by pulling latch (1) forward, pivoting dust cup
out and lifting up. To replace dust cup, put bottom of dust cup in
place by aligning tabs in slots and pivot top assembly back into
place. Push down on latch (1), making certain that latch securely
snaps and overlaps tabs at top of dust cup.
Check and clean the pleated filter once a month to maintain good performance. The filter can be cleaned by washing
with mild detergent and warm water. Be sure pleated filter is completely dry before reinstalling.
To clean the Pleated Filter:
1. Grasp yellow filter frame and twist counter clockwise to remove.
2. Shake vigorously and brush off dust and lint.
3. If filter needs further cleaning, wash in warm water using a mild detergent.
4. Do not submerge gray dust cup lid, wipe only with a damp cloth.
5. When all parts are completely dry, replace filter on gray dust lid by twisting clockwise to snap and lock in place.
Use a Genuine Electrolux replacement pleated
filter. Call Electrolux on 08706 055055 for
assistance.
10
1
Gray Filter

Assembly

1
Slots
Pleated
Filter
Tabs
3