General - Panasonic CQ-R253U Operating Instructions Manual

General

E
N
G
L
I
S
Power
H
Turn the key in the ignition until the accessory indicator lights.
1
Power on: Press [PWR] (power).
Power off: Press [PWR] (power) again.
APM
Volume
Turn the knob clockwise to increase volume,
and counterclockwise to decrease volume.
Volume level (0 to 40)
Up
Down
10
CQ-R253U
A C C
O N
Remote control sensor (REMOTE) ( page 18)
REMOTE
DOLBY B NR
CQ-R253U
TUNE
TRACK
DISC SCAN REPEAT RANDOM
MUTE MUTE
1 MTL NR 2 3 TPS REP 4 5 B•S 6 MONO
[DISP] (display)
Mute
Press [MUTE] to mute the sound completely.
MUTE indicator
Press [MUTE] again to cancel.
Loudness
Press and hold for more than 2 seconds [MUTE]
(LOUD) to enhance bass and treble tones at low or
medium volume.
Loudness indicator
Press and hold for more than 2 seconds [MUTE]
(LOUD) again to cancel.
Note: If no operation takes place for more than 5 seconds
in audio mode (2 seconds in volume mode), the display
returns to the regular mode.
Audio Mode
(Bass/Treble/Balance/Fader)
q
Push [SEL] to select the audio mode.
Volume Bass Treble
Fader Balance
CQ-R253U
APM
DISC SCAN REPEAT RANDOM
MUTE
1 MTL NR 2 3 TPS REP 4 5 B•S
w
Turn [VOL] clockwise or counterclockwise to
change each level.
Bass:
default: 0 dB
Adjustable range: –12 to +12 dB (by 3 dB step)
Treble:
default: 0 dB
Adjustable range: –12 to +12 dB (by 3 dB step)
Balance:
R (right speaker) or L (left speaker)
Adjustable range: Balance center
1 to 15 (by 1 dB step) (default)
Fader:
F (front speaker) or R (rear speaker)
Adjustable range: Fader center
1 to 15 (by 1 dB step) (default)
Clock Setting
The 12-hour system is used for the clock.
Initial Time
q
Press [DISP] (clock).
"AdJ" is displayed when the
clock is not adjusted.
push
REMOTE
DOLBY B NR
TUNE TUNE
TRACK TRACK
6 MONO
[] TUNE], [[ TUNE] (Hours, minutes)
Hours
w
Press and hold [DISP] (clock) for more than 2
seconds.
(Hours blink.)
e
Press [] TUNE] or [[ TUNE].
(Hours set.)
Minutes
r
Press [DISP] (clock).
(Minutes blink.)
t
Press [] TUNE] or [[ TUNE].
(Minutes set.)
y
Press [DISP] (clock).
(End.)
Note: Press and hold [] TUNE] or [[ TUNE] to
change numbers rapidly.
Time Reset
Press and hold [DISP] (clock) for more than
2 seconds to activate the time setting mode to reset
the time.
Then, repeat steps to .
CQ-R253U
E
N
G
L
I
S
H
2
11