Anti-Theft System - Panasonic CQ-R253U Operating Instructions Manual

Installation
E
(Continued)
N
G
L
I To Remove the Unit
S
H
Switch off the power of the unit.
17
1 Remove the removable face plate.
Press [ ]. (release button). The
removable face plate will be released.
Release button
REMOTE
NR
TUNE
2 Remove the Trim Plate i with a screwdriver.
3 Insert the Dismounting Plates, u along
the grooves on both sides of the main unit
until "click" is heard.
Pull out the unit while pushing the plates
further inside.
Insert the tab
end in the
outer groove.
"Click"
4
Remove the unit pulling with both hands.
26
CQ-R253U
Contact
Push
i Trim Plate
Screwdriver
Insert
u Dismounting Plate
Pull out

Anti-Theft System

This unit is equipped with a removable face plate. Removing this face plate makes the radio totally inoperable.
Place the Removable Face Plate
into Case
Switch off the power of the unit.
Remove the removable face plate. ( page 26)
Gently press the bottom of the case and open the
cover. Place the face plate into the case and take it with
you when you leave the car.
Install Removable Face Plate
Slide the left side of the removable face plate in place.
Press the right end of the removable face plate until
"click" is heard.
Caution:
• This face plate is not waterproof. Do not expose it to water or excessive moisture.
• Do not remove the face plate while driving your car.
• Do not place the face plate on the dashboard or nearby areas where the temperature rises to high level.
• Do not touch the contacts on the face plate or the main unit, since this may result in poor electrical contacts.
• If dirt or other foreign substances get on the contacts, wipe them off with a clean and dry cloth.
Removable face plate case
Tab
Cutout
CQ-R253U
E
N
G
L
I
S
H
18
27