Troubleshooting - Panasonic ER-GP80 Operating Instructions Manual

Lubrication
• Apply the oil to the clipper before and after each use.
Apply a drop of the oil to each
indicated point.
Failure to apply the oil may cause the
following problems due to rust, wear or
burn out.
- The clipper has become blunt.
- Shorter operating time.
- Louder sound.
► Replacement parts
Replacement part is available at your dealer or Service Centre
Replacement parts for ER‑GP80
Cleaning the charging stand
Use the cleaning brush to clean hair trimmings and dust in the
charging plug or in the hole on the bottom surface.
12
Blade WER9900

Troubleshooting

Problem
The clipper has become
blunt.
Clipper stopped functioning.
The clipper cannot be
charged.
Clipper can be used for only
about 10 minutes even after
charging.
Makes a loud sound.
If the problems still cannot be solved, contact the store where you
purchased the unit or a service centre authorised by Panasonic for
repair.
Action
Charge the clipper.
(See page 9.)
Clean the blade and apply oil.
(See pages 11 and 12.)
Replace the blade.
(See page 11.)
Charge the clipper.
Or use with the AC operation.
(See page 9.)
Push the main body into the
charging stand or appliance
plug all the way.
Charge within the
recommended charging
temperature of 10 °C to 35 °C.
Have the battery replaced by an
authorized service centre.
Confirm that the blade is
properly attached.