Table of Contents
Advertisement
ª
Selecting the remote control mode
If 2 cameras are used simultaneously, set the mode for one pair
of movie camera and remote control to [VCR1] and that of the
other pair to [VCR2]. This will prevent interference between the
2 pairs. (The default setting is [VCR1]. When the button-type
battery is replaced, the setting will revert to the default [VCR1].)
1
Setting on the camera:
Set [SETUP] >> [REMOTE] >> [VCR1] or [VCR2].
2
Setting on the remote control:
STILL ADV
2
[VCR1]:
Press [D] and [∫] simultaneously. 1
[VCR2]:
Press [E] and [∫] simultaneously. 2
ª
Concerning the button-type battery
≥When the button-type battery runs down, replace it with a new
battery (part number: CR2025). The battery is normally
expected to last about 1 year, but it depends on operation
frequency.
≥Keep the button-type battery out of the reach of children.
≥If the remote control mode of the camera and that of the
remote control do not match with each other, "REMOTE" will
appear. When the remote control is operated for the first time
after the camera is turned on, "CHECK REMOTE MODE"
(
) will appear and operation is impossible. Set the same
-68-
remote control mode.
≥The remote control is intended for indoor operation. Outdoors
or under strong light, the movie camera may not operate
properly even within the usable ranges.
≥Within a 1 metre range, you can operate the remote control
from beside the remote control sensor (LCD monitor side) of
the movie camera.
VOL
PAUSE STILL ADV
1
STOP
VAR
Before using
Using the External Stereo Microphone
ª
External stereo microphone
Supplied external stereo microphone can be switced to record
sound in either stereo or monaural.
(1)
(1)
Wind Shield (Microphone condenser)
(2)
Off/On mode selector switch [OFF/MONO/STEREO]
-52-
(3)
Battery check lamp [BATTERY]
(4)
[WIND CUT OFF/ON] switch
(5)
Stereo mini-plug cord
(6)
Shoe
-52-
(7)
Shoe lock
-52-
ª
Inserting a Battery
1
Remove the battery cover from the microphone.
≥Press the [
] mark on the cover in the direction of arrow
1 and slide the cover in the direction of arrow 2.
2
Insert the Battery with the (s) end first as shown in the
figure.
≥Be sure to insert the Battery with the (j) and (i) ends
facing the proper directions.
3
Replace the battery cover.
≥When the battery is exhausted, purchase a new "AAA",
"UM-4" or "R03" type battery and insert it in the same way as
explained above.
≥Do not short-circuit the battery.
≥Remove the Battery if you will not use the microphone for one
month or longer.
(2) (3) (4)
(5) (6) (7)
-52-
-52-
-52-
1
2
-
+
51
VQT0S76
Advertisement
Chapters
Table of Contents
