Using A Conditional Access Module; 6Wdqge\ 1Rwl¿Fdwlrqv - Hitachi 24HXJ15U Instruction Manual

Using a Conditional Access Module

IMPORTANT: Insert or remove the CI module only when
the TV is SWITCHED OFF.
,Q RUGHU WR ZDWFK FHUWDLQ GLJLWDO FKDQQHOV D FRQGLWLRQDO
access module (CAM) can be necessary. This module
must be inserted in the CI slot of your TV.
1. Obtain the Conditional Access Module (CAM) and the
YLHZLQJ FDUG E\ VXEVFULELQJ WR D SD\ FKDQQHO FRPSDQ\
then insert those to the TV using the following procedure.
2. Insert the CAM and then the viewing card to the
slot that is located in the terminal cover at the rear
side of the TV.
3. 7KH &$0 VKRXOG EH FRUUHFWO\ LQVHUWHG LW LV
impossible to insert fully if reversed. The CAM or
the TV terminal may be damaged if the CAM is
forcefully inserted.
4. &RQQHFW WKH 79 WR WKH PDLQV VXSSO\ VZLWFK RQ
and then wait for few moments until the card is
activated.
5. :KHQ QR PRGXOH LV LQVHUWHG ³No Common
Interface module detected" message appears
on the screen.
You can refer to the module instruction manual for details
of the settings.
For any help concerning set up and use of your TV please call the Customer Helpline: 0845 604 0105
6WDQGE\ 1RWL¿FDWLRQV
If the TV does not receive any input signal (e.g. From
DQ DHULDO RU +'0, VRXUFH IRU  PLQXWHV WKH 79 ZLOO
JR LQWR VWDQGE\ :KHQ \RX QH[W VZLWFKRQ WKH 79 WKH
following message will be displayed:
:KHQ WKH $XWR 7Y 2II WLPHRXW LV UHDFKHG WKH IROORZLQJ
message will be displayed on the screen. Select YES
to shut down the TV. Select NO to cancel. The TV
ZLOO VZLWFK RII DV ZHOO LI \RX GR QRW PDNH D VHOHFWLRQ
on this screen.
If the TV has been left on and not been operated for
 KRXUV WKH 79 ZLOO JR LQWR VWDQGE\ :KHQ \RX QH[W
VZLWFKRQ WKH IROORZLQJ PHVVDJH ZLOO EH GLVSOD\HG
English - 12 -