Panasonic EY74A2 Operating Instructions Manual page 12

Speed Control Function
EN
Setting the maximum speed.
1. Press the speed setting button and select a speed.
The speed changes to H, M, L and OFF (the light is off) in this order.
2. Select OFF to release it.
Display
H
M
L
OFF
• Default setting: OFF
• The speed is the same at both 18 V and 14.4 V in this setting.
• If a high mode is chosen, the speed is set as the table above.
LED Light
Press the light button and set illumination
condition.
Illuminated
Illuminates by pressing button.
The light turns off when the tool
has not been used for more
than 5 minutes or just after
attaching the battery pack.
Depress the trigger switch and
operate the tool once.
Interlocking trigger
Illuminates when depressing the
trigger switch.
Turns off when the trigger is
released.
Off
The light illuminates with very low current,
and it does not adversely affect the perfor-
mance or its battery capacity.
CAUTION:
• The built-in LED light is designed to
illuminate the small work area tempo-
rarily.
• Do not use it as a substitute for a
regular flashlight, since it does not
have enough brightness.
EY74A2_EU.indb 12
Low mode
Approx. 300 min (rpm)
-1
Approx. 200 min (rpm)
-1
Approx. 150 min (rpm)
-1
Ordinary speed
18 V Approx. 470 min
14.4 V Approx. 400 min
High mode
Approx. 1000 min
Approx. 670 min
Approx. 500 min
Ordinary speed
(rpm) 18 V Approx. 1580 min
-1
(rpm) 14.4 V Approx. 1350 min
-1
CAUTION: DO NOT STARE INTO
BEAM.
Use of controls or adjustments or perfor-
mance of procedures other than those
specified herein may result in hazardous
radiation exposure.
Battery Level Indicator
Press the battery level button.
Battery level indicator shows battery level
in three levels while pressing the button.
NOTE:
The indicator will not show the battery
level even the button is pressed in the
following cases.
• The main unit is powered off.
• Just after attaching the battery pack
• The main unit or battery level button is
not operated for approx. five minutes.
Press the battery level button again
after depressing the trigger switch.
• If the battery temperature is high, stop
the operation and wait until the battery
temperature is low.
- 12 -
(rpm)
-1
(rpm)
-1
(rpm)
-1
(rpm)
-1
(rpm)
-1
2015/07/16 11:32:15