Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when using the wall-hanging bracket or repacking the TV.
1 Remove the assembly screws
2 Pull out the pedestal from the TV.
3 Remove the assembly screws
Connections
External equipment and cables shown are not supplied with this TV.
Ensure that the unit is disconnected from the mains socket before attaching or disconnecting any leads.
Check the type of terminals and cable plugs are correct when connecting.
Always use a fully wired SCART or HDMI cable.
Keep the TV away from electronic equipment (video equipment, etc.) or equipment with an infrared sensor.
Otherwise, distortion of image / sound may occur or operation of other equipment may be interfered.
Also read the manual of the equipment being connected.
Terminals
8
Basic connections
Mains lead and aerial
Mains lead
(supplied)
AC 220-240 V
50 / 60 Hz
6
.
from the bracket.
1
4
2
5
3
6
7
DVB-C, DVB-T, Analogue
Mains lead
Insert the mains plug firmly into place.
When disconnecting the mains lead, be absolutely sure to
disconnect the mains plug at the socket outlet first.
1
CI slot
2
Headphone jack
3
USB port
4
HDMI1 - 2
5
Terrestrial / cable terminal
(see below)
6
AV1 (SCART)
7
AV2 (COMPONENT / VIDEO)
(p. 7)
8
DIGITAL AUDIO
Terrestrial aerial
RF cable
(p. 8)
(p. 8)
(p. 7, 8)
(p. 7)
Cable