Electrolux EUF2540MHW User Manual page 11

Problem
The compressor operates
continually.
The compressor does not
start immediately after
pressing the ActionFreeze,
or after changing the tem‐
perature.
Water flows on the floor.
Temperature cannot be
set.
Door is misaligned or inter‐
feres with ventilation grill.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The ActionFreeze func‐
tion is switched on.
This is normal, no error
has occurred.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The ActionFreeze func‐
tion is switched on.
The appliance is not lev‐
elled.
The temperature regula‐
tor is not set correctly.
Food products placed in
the appliance were too
warm.
The door has been
opened often.
The ActionFreeze func‐
tion is switched on.
There is no cold air circu‐
lation in the appliance.
ENGLISH
Solution
Refer to "Operation" chapter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "ActionFreeze func‐
tion".
The compressor starts after
a period of time.
Attach the melting water out‐
let to the evaporative tray.
Switch off ActionFreeze
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "ActionFreeze function".
Refer to "Levelling".
Set a higher/lower tempera‐
ture.
Allow food products to cool
to room temperature before
storing.
Open the door only if neces‐
sary.
Refer to "ActionFreeze func‐
tion".
Make sure that there is cold
air circulation in the appli‐
ance.
11