Table of Contents
Advertisement
Level of protection against ingress of solid particles and
moisture ensured by the protective cover, except where the
low voltage equipment has no protection against moisture
Water supply pressure
1)
Water supply
Maximum Load
Energy Efficiency Class
Spin Speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
Troubleshooting
WARNING!
Refer to Safety chapters.
Introduction
The start of the appliance does not occur or it
stops during operation.
First try to find a solution to the problem (refer
to the table). If not, contact the Authorised
Service Centre.
With some problems, the acoustic signals
operate. The indicator of button
red and one of the indicators comes on, to
show an alarm code:
Possible failures
Problem
The programme does not
start.
www.zanussi.com
Minimum
Maximum
Cotton
Maximum
flashes in
•
Make sure that the mains plug is connected to the mains socket.
•
Make sure that the appliance door is closed.
•
Make sure that there is not a damaged fuse in the fuse box.
•
Make sure that the Start/Pause has been pressed.
•
If the delay start is set, cancel the setting or wait for the end of count-
down.
•
Deactivate the Child Lock function if it is on.
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water
8 kg
A+++
1200 rpm (ZWF 81260W)
1400 rpm (ZWF 81460W)
•
- The appliance does not fill with water
properly.
•
- The appliance does not drain the water.
•
- The appliance door is open or not
closed correctly. Check the door!
• The indicator of button
times and 1 (or 2 or 3) time(s) in yellow: The
mains supply is unstable. Wait until the
mains supply is stable.
WARNING!
Deactivate the appliance before you
do the checks.
Possible solution
flashes in red 11
15
Advertisement
Table of Contents
