Replacing The Light Bulb - GE DVM7195 Owner's Manual

Replacing the light bulb.

Remove screw.
About the exhaust feature.
Charcoal filter
Microwave
Popcorn Beverage Express
Power Auto
Warm
Level Cook
Convection Combination Convection
Bake Fast Bake Roast
Reheat
Defrost
Weight/Time
Cancel Start
Off Pause
Lock Controls
Hold 3 Sec
Timer Cook Set
On/Off Time Clock
Options Help
Turntable Surface Vent Fan
Light
Reusable vent filters
(on all models).
Popcorn Beverage Microwave
Express
Warm Power Auto
Level Cook
Convection Combination Convection
Bake Fast Bake Roast
Reheat
Defrost
Weight/Time
Cancel Start
Off Pause
Lock Controls
Hold 3 Sec
Timer Cook Set
On/Off Time Clock
Options Help
Surface Vent Fan
Turntable Light
Cooktop Light/Nite Light
Replace with a 120 volt, 40 watt (max.)
halogen bulb. Order WB08X10051 from your
GE supplier.
1
To replace the cooktop light/nite light, first
disconnect the power at the main fuse or
circuit breaker panel, or pull the plug.
2 Remove the screw from the side of the light
compartment cover and lower the cover
until it stops.
Vent Fan
The vent fan has two metal reusable vent filters.
Models that recirculate air back into the room
also use a charcoal filter.
Reusable Vent Filters
The metal filters trap grease released by foods
on the cooktop. They also prevent flames from
foods on the cooktop from damaging the inside
of the oven.
Removing and Cleaning the Filters
To remove, slide them to the rear using the tabs.
Pull down and out.
To clean the vent filters, soak them and then
swish around in hot water and detergent. Don't
use ammonia or ammonia products because
they will darken the metal. Light brushing can be
used to remove embedded dirt.
3 Be sure the bulb is cool before removing.
Break the adhesive seal by gently
unscrewing the bulb.
4 Screw in the new bulb, then raise the light
cover and replace the screw. Connect
electrical power to the oven.
For this reason, the filters must always be in
place when the hood is used. The vent filters
should be cleaned once a month, or as needed.
Rinse, shake and let dry before replacing.
To replace, slide the filters into the frame slots
on the back of each opening. Press up and to the
front to lock into place.
23