Table of Contents
Advertisement
Problem
Water flows on the floor.
The temperature in the appliance
is too low/too high.
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.
Replacing the lamp
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Remove the lamp cover (refer to the
illustration).
Installation
WARNING!
Refer to Safety chapters.
www.zanussi.com
Possible cause
Food products prevent that water
flows into the water collector.
The melting water outlet is not
connected to the evaporative tray
above the compressor.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The food products' temperature
is too high.
Many food products are stored at
the same time.
The door has been opened often. Open the door only if necessary.
There is no cold air circulation in
the appliance.
3. Replace the used lamp with a new lamp of
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
Location
To ensure best performance, install the
appliance well away from sources of heat such
Make sure that food products do
not touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Store less food products at the
same time.
Make sure that there is cold air
circulation in the appliance.
the same power and specifically designed
for household appliances (the maximum
power is shown on the lamp cover).
"Installation".
gaskets. Contact the Authorised Service
Centre.
Refer to the assembly instructions
for the installation.
Solution
9
Advertisement
Table of Contents
