Preparing The Remote Control; Demo Function - Panasonic SC-PM46 Operating Instructions Manual

Simple setup (continued)
Optional antenna connections
FM outdoor antenna
• Never use an outdoor antenna during a lightning storm.
• You can connect the FM outdoor antenna for better reception. Please consult your dealer for installation.
• Disconnect the FM indoor antenna if an FM outdoor antenna is installed.
• Connect the AM outdoor antenna without removing the AM loop antenna. Run 5 to 12 m of vinyl-covered wire horizontally along a window
or other convenient location.

Preparing the remote control

CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent
type recommended by the manufacturer. Dispose
of used batteries according to the manufacturer's
instructions.

DEMO function

6
6
FM outdoor antenna
(not included)
75 
coaxial cable
(not included)
■ Batteries
• Insert so the poles (+ and –) match those in the remote control.
• Remove if the remote control is not going to be used for a long period of time.
• Do not use rechargeable type batteries.
• Do not heat or expose to fl ame.
• Do not leave the battery(ies) in an automobile exposed to direct sunlight for a long
• Mishandling of batteries in the remote control can cause electrolyte leakage,
Do not:
• mix old and new batteries;
• use different types of batteries at the same time;
• take apart or short-circuit;
• attempt to recharge alkaline or manganese batteries;
• use batteries if their covering has been peeled off.
■ Use
When the unit is fi rst plugged in, a demonstration of its functions may be shown on
the display.
If the demo setting is off, you can show a demonstration by selecting "DEMO ON".
Press and hold [7, –DEMO].
The display changes each time the button is held down.
While in standby mode, select "DEMO OFF" to reduce power consumption.
AM outdoor antenna
AM outdoor antenna
(not included)
Store in a cool, dark place.
period of time with doors and windows closed.
which may cause a fi re.
Aim at the remote control sensor, avoiding obstacles, at a maximum range of 7 m
directly in front of the unit.
Refer to page 7 for remote control signal sensor position.
AM loop antenna
(included)