Table of Contents
Advertisement
Installation
(continued)
Mounting the TV Antenna
21
Caution
Be sure to install the TV antenna on the inner side of
the rear window.
Be sure to connect the power lead of the TV antenna
to ACC power DC 12 V.
Keep the antenna away from the external amplifi er
and the rear speaker cord as much as possible.
Preparations:
Remove the upholstery at both sides of the
rear window to establish a ground.
Remove the upholstery.
Observe the following to enhance adherability.
Wipe the inner surface of the rear window with a
wet and soft cloth along the heating wire. But do
not leave water droplets on the glass.
When the outside-air temperature is less than 20C,
switch on the rear window defogger or the car heater
to warm the surface of the rear window for approx. 5
minutes.
For a hatchback type:
Stick the grounding plate skillfully and hold the loose
antenna element with the Antenna Clamp so that the
element will not become caught in the hatchback door.
Adjust the cord length so that the cord does not
interfere with the movement of the hatchback door,
and secure the cord with Cord Clamp .
22
CY-TUP153N
Straighten the bent antenna element.
Confi rm the adhering positions.
Shorter side
Longer
side
Affi x the antenna temporarily with adhesive tape after
confi rming the antenna position.
Antenna cable identifi cation
(for each antenna)
To TV antenna
connector on
the unit.
Antenna Cord
Power lead
(Red)
(Fuse 0.5 A)
To ACC power,
ACC 0.5A
0.5A
+12 V DC.
To another's
power lead
Ground Lead
(Black)
To a clean, bare metallic part
of the car chassis.
Insert the grounding plate into the antenna body and hold the antenna element with the Antenna
Clamp .
Select a suitable screw point for
the grounding plate to adhere
to a metal part and remove the
screw and the terminal cover.
Screw points
Follow the steps below to install the grounding plate.
Insert the grounding plate into the antenna body.
Hold the grounding plate with the terminal cover.
Screw the grounding plate.
Hold the antenna element with the Antenna Clamp .
Some models restrict the installation of
the TV antenna due to rear window size
or open/close of the hatch. Contact your
dealer.
Cord routing
Hold the cord with a
Cord Clamp .
Route the cord behind
Route the cord inside the
the rear seat and affi x it
upholstery and under the
with adhesive tape.
carpet.
Screw
Terminal cover
Insert
Grounding Plate
Caution
Be sure to connect the grounding plate. Otherwise,
desensitization will occur.
Peel the sheet from the back of the
antenna body and affi x it. Then, affi x the
grounding plate on a metal part.
Follow the steps below to affi x the antenna securely.
Affi x the antenna body.
Straighten the antenna element and affi x it.
Put the Antenna Clamp on the center of the
antenna element.
Adjust the angle and position of the grounding plate
and affi x it.
Adjust
For some models, you cannot straighten the
longer element.
Comfortably curving
No bending
Caution
Avoid contacting the adhesive surface.
Do not re-adhere to avoid weakening adherability.
Avoid adhering on the heating wire as much as
possible.
CY-TUP153N
22
23
Advertisement
Table of Contents
