■
Moving the TV
Hold the specified parts as shown to stand the TV up and move it with two people.
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when using the wall-hanging bracket or repacking the TV.
1 Put the TV onto a work table with the screen panel down on the clean and soft cloth.
2 Remove the assembly screws
3 Remove the assembly screws
4 Remove the pedestal from the TV.
5 Remove the assembly screws
Adjusting the panel to your desired angle
●
Do not place any objects within the full rotation range.
Preventing the TV from falling over
Using the fall-prevent screw hole and a screw (commercially available), securely fix the body of the pedestal to the
installation surface.
●
The place where the pedestal is to be fixed should be thick enough and made of hard material.
Installing / removing remote's batteries
1
Hook
2
Note the correct
polarity (+ or -)
6
from the cover.
from the TV.
from the bracket.
15°
15°
(View from the top)
Caution
●
Pull open
Incorrect installation may cause battery leakage and corrosion,
resulting in damage to the remote control.
●
Do not mix old and new batteries.
●
Replace only with same or equivalent type. Do not mix different
battery types (such as alkaline and manganese batteries).
●
Do not use rechargeable (Ni-Cd) batteries.
●
Do not burn or break up batteries.
Close
●
Do not expose batteries to excessive heat such as sunshine, fire or
the like.
●
Make sure you dispose of batteries correctly.
●
Ensure batteries are replaced correctly, there is danger of explosion
and fire if battery is reversed.
●
Do not disassemble or modify the remote control.
Screw (not supplied)
Diametre: 3 mm
Length: 15 - 20 mm
Screw hole