Preventing The Tv From Falling Over - Panasonic Viera TX-L32ET5E Operating Instructions Manual

Lcd television
Hide thumbs Also See for Viera TX-L32ET5E:
Table of Contents

Advertisement

Available languages

Available languages

Ensure that the TV does not fall over.
If the TV is knocked or children climb onto the pedestal with the TV installed, the TV may fall over and personal injury
may result.
Two or more people are required to install and remove the TV.
If two or more people are not present, the TV may be dropped, and personal injury may result.
When removing the pedestal from the TV, do not remove the pedestal by the methods other than the specified
procedure.
(see below)
Otherwise the TV and / or pedestal may fall over and become damaged, and personal injury may result.
Assembly screw (4)
M5 × 15
Assembly screw (4)
M4 × 25
1
Assembling the pedestal
Use the assembly screws
to the base
securely.
Make sure that the screws are securely
tightened.
Forcing the assembly screws the wrong way
will strip the threads.
C
Front
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way
when using the wall-hanging bracket or repacking the
TV.
1 Remove the assembly screws
2 Pull out the pedestal from the TV.
3 Remove the assembly screws

Preventing the TV from falling over

Using the fall-prevent screw hole and a screw (commercially available), securely fix the body of the pedestal to the
installation surface.
The place where the pedestal is to be fixed should be thick enough and made of hard material.
Bracket
TBL5ZA32911 (TX-L32ET5E)
TBL5ZA32831 (TX-L37ET5E)
TBL5ZA32921 TX-L42ET5E
to fasten the bracket
A
D
from the TV.
from the bracket.
Base
TBL5ZX03551 (TX-L32ET5E)
TBL5ZX03541 (TX-L37ET5E)
(
)
TBL5ZX03531 (TX-L42ET5E)
TBL5ZX03511 (TX-L47ET5E)
TX-L47ET5E
TBL5ZX03851 (TX-L55ET5E)
TX-L55ET5E
2
Securing the TV
Use the assembly screws
Tighten the four assembly screws loosely at first, then
tighten them firmly to fix securely.
Carry out the work on a horizontal and level surface.
Hole for pedestal
installation
Adjusting the panel to your desired angle
Do not place any objects within the full rotation range.
Screw (not supplied)
Diametre
55 inches model: 4 mm
Other inches model: 3 mm
Length: 25 - 30 mm
Screw hole
to fasten securely.
Arrow mark
15°
15°
(View from the top)
B
5

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents