Maintenance - Panasonic SC-HTE180 Operating Instructions Manual

█
®
Bluetooth
Pairing cannot be done.
• Check the Bluetooth ® device condition.
• The device is out of the 10 m communication range. Move
the device nearer to the system.
The device cannot be connected.
• The pairing of the device was unsuccessful. Do pairing
again.
• The pairing of the device has been replaced. Do pairing
again.
• This system might be connected to a different device.
Disconnect the other device and try pairing the device
again.
The device is connected but audio cannot be heard
through the system.
• For some built-in Bluetooth
audio output to "SC-HTE180" manually. Read the
operating instructions of the device for details.
Sound from the device is interrupted.
• The device is out of the 10 m communication range. Move
the device nearer to the system.
• Remove any obstacle between the system and the device.
• Other devices that use the 2.4 GHz frequency band
(wireless router, microwaves, cordless phones, etc.) are
interfering. Move the device nearer to the system and
distance it from the other devices.
• Select "MODE 1" for stable communication.
The one-touch connection (NFC) is not working.
• Make sure the NFC feature of the NFC-compatible device
is switched on. Touch and hold the device to the NFC
touch-area of this system again.
Playback image and sound are not synchronised.
• Restart the playback app of the device.
█
Main unit displays
" F61"
• There is a problem with the amplifier of the system.
• Disconnect the AC mains lead and consult the dealer.
F70 HDMI"
"
• Check HDMI connection.
• Switch off the system and then switch it on again.
• Disconnect the HDMI cable.
F76"
"
• There is a problem with the power supply.
• Disconnect the AC mains lead and consult the dealer.
®
devices, you have to set the
System memory reset
Reset the memory when the following situations occur:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
1
While the system is switched on, press and hold
[1] on the main unit for a minimum of 4 seconds.
"RESET" is shown.
2
Release [1].
3
Switch off the system and then switch it on again.
All the settings are set back to the factory preset.
Note:
The remote control code will set back to "REMOTE 1" after
memory reset, refer "Remote control code" on how to change
to "REMOTE 2".
Remote control code
When other Panasonic equipment responds to the
remote control of this system, change the remote control
code for this system.
Preparation
• Switch off all other Panasonic products.
• Switch on this system.
• Aim the remote control at the remote control sensor of
this system.
█
To set the code to "REMOTE 2"
Press and hold [MUTE] and [OK] for a minimum of
4 seconds.
"REMOTE 2" is shown.
█
To set the code to "REMOTE 1"
Press and hold [MUTE] and [T] for a minimum of
4 seconds.
"REMOTE 1" is shown.

Maintenance

To clean this system, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this
system.
• Before using chemically treated cloth, read the
instructions that came with the cloth carefully.
13
13