Table of Contents
Advertisement
External Timer Recording
The unit can be made to record using an external timer to turn on its power.
AG-RT850
PULL OPEN
TRACKING /
V-LOCK
RESET
External timer recording operations
1
Check that a video cassette with its tab intact has
been inserted.
•
If the video cassette tape has not been inserted or if its accidental erasure prevention tab has been broken,
EXT will flash on the display, and external timer recording cannot be conducted.
•
Since it takes some moments for recording to start, set the start time for timer recording one minute earlier.
•
Depending on the tape position, some of the images at the start of the external timer recording may not be
recorded or may record over the images at the end of the previous external timer recording.
Auto Repeat Recording/Auto Rewinding
Auto repeat recording:
Auto rewinding:
This function automatically rewinds the tape to the start when the tape end is detected in the
recording mode.
1
Check that a video cassette with its tab intact has
been inserted.
2
Set the MENU/REC LOCK switch to MENU to
display the menu screens. Press the page button
to display Menu Screen 4 on the TV monitor.
[REC MODE]
REC T-MODE : OFF
TAPE IN : STOP
TAPE END : STOP
[VIDEO MODE]
PICTURE : NORMAL
NOISE_B MASK : OFF
Notes of operation
•
When auto repeat recording is to be performed, do not neglect the routine inspections. Since the image
deteriorates when the same tape is used over and over again for auto repeat recording, replace the tape with a
new one after about 50 recordings.
•
Alarm signals are not accepted during auto rewinding, and so alarm recording is not performed.
•
If an alarm signal is supplied during auto repeat recording, the alarm recording mode is established. If the tape
then reaches its end, auto repeat recording is performed but alarm recording is released.
•
When the power cord has come out of the socket or a power failure has occurred, no operations will be acknowl -
edged for about 30 seconds after the power has been restored: this is to protect the tape.
Power Cord
EJECT
REC REVIEW
REC
(supplied)
REC
REV
FWD
COUNTER /
TIME MODE
SEARCH
ALARM
This function automatically rewinds the cassette tape when its end is detected in the
recording mode, and it repeats recording from the start of the tape.
P4
MODE : AUTO
To AC IN
Timer
2
Set the TIMER MODE (REC MODE) switch to EXT
TIMER so that EXT lights on the display. At the set
time, power is supplied from the external timer and
the unit is set to the recording mode.
3
Press the shift (
TAPE END. Press the set (+ or –) button to display
REPEAT for auto repeat recording or REW for auto
rewinding.
4
"R" lights on the display.
•
If auto rewinding has been selected, "R" is
cleared.
5
Upon completion of the settings, set the MENU/
REC LOCK switch to OFF. The regular screen is
restored.
19
(Audio timer available from dealer)
) button to move the flashing to
TAPE END : REPEAT
Advertisement
Table of Contents
