Table of Contents
Advertisement
Menu Screens
MENU SCREEN 2
The time/date display position, monitor screen blue display and buzzer settings are performed on Menu Screen 2.
5
Display position selection
This selects the position where the date and time
are to be displayed on the TV monitor.
(L-UPPER ↔ R-UPPER ↔ L-BOTTOM ↔ R-
BOTTOM ↔ CENTRE ↔ OFF ↔ L-UPPER...)
6
Blue display
This sets a blue display on the monitor screen at all
times except while recording or playback is in progress.
BLUE: The display on the monitor screen is blue at
all times except while recording or playback is in
progress.
CAMERA: The pictures from the video input
connector are shown on the monitor screen at all
times except while playback is in progress.
7
Setting of the buzzer sound
ALARM: The buzzer sounds once alarm recording is
performed.
TAPE END: When the tape end is reached in the
recording mode, the buzzer sounds while the tape is
at the end.
TAPE REMAIN: The buzzer sounds when there is
only about 3% (with an E-180 tape) of the tape
remaining before the end is reached in the recording
mode.
ERR WARN: The buzzer sounds when the unit is set
to the warning status.
MENU SCREEN 3
The alarm recording mode and terminal output are set on Menu Screen 3.
8
Setting of alarm recording and recording time
mode during alarm recording (see page 20)
When there is an alarm input during recording in
the time lapse mode, the recording time mode is
switched to the designated mode (9H), and the
details of the alarm status are faithfully recorded.
9
Alarm recording duration setting
This sets the time allowed to elapse from the start
of alarm recording until its end. This time can be
set individually from 30 sec. to 10 min.
(30 SEC ↔ 1 MIN ↔ 2 MIN ↔ 3 MIN ↔ 5 MIN ↔
10 MIN ↔ CONTINUE ↔ MANUAL ↔ 30 SEC...)
CONTINUE: Alarm recording continues until the
tape end.
MANUAL: Alarm recording is performed while the
alarm input continues.
To release the buzzer:
ALARM: Release alarm recording.
TAPE END: Transfer the mode from the tape end or
press the STOP button.
TAPE REMAIN: Transfer the mode (but not to
PAUSE or REC REVIEW) from the recording mode
or press the REC button.
ERR WARN: Release the warning status.
•
When TAPE END or TAPE REMAIN has been set
to OFF, the buzzer will not sound; however, the
REMAIN display will remain lit or flashing.
•
When TAPE END or TAPE REMAIN has been set
to ON, REMAIN lights or flashes on the display
tube at the same time as the buzzer sounds.
They cease flashing when the buzzer is released.
Note:
The remaining tape is displayed only with E-180
tape. It is not displayed when any other tapes are
used.
0
Alarm recall (see page 21)
This checks the date/time when an alarm signal
was input (up to 4 times).
q
Terminal connector output signal setting
ERR WARN: When trouble has occurred in the unit
(AUTO OFF), the LOW signal is output.
REC: The LOW signal is output during recording.
10
Advertisement
Table of Contents
