Useful Information - Panasonic KX-TCD150E Operating Instructions Manual

TCD150E(E).book Page 14 Wednesday, May 25, 2005 4:58 PM

Useful Information

Useful Information
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the AC
adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.
Problem
w is flashing.
I cannot make or receive calls.
The unit does not ring.
The handset display is blank.
14
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Cause & solution
L The handset is too far from the base unit. Move
closer.
L The AC adaptor is not connected. Check the
connections.
L You are using the handset or base unit in an area
with high electrical interference. Locate the
handset and base unit away from interference
sources, such as antenna and mobile phones.
L The handset registration is cancelled. Register the
handset to the base unit using the following
method.
1
{j/OK}
2
"SETTING HS" i {>}
3
"REGISTRATION" i {>}
4
"REGISTER HS" i {>}
5
Press and hold {x} on the base unit until the
registration tone sounds.
L The rest of the procedure must be completed
within 1 minute.
6
Select a base unit number ({v}). i {>}
7
Wait until "BS PIN" is displayed. i Enter
base unit PIN (default: "0000"). i {>}
L A confirmation tone will sound, and w will
stop flashing.
L The AC adaptor or telephone line cord is not
connected. Check the connections.
L The call bar feature is turned on. Turn it off (page
10).
L You dialled a call restricted number (page 12).
L The key lock feature is turned on. Turn it off (page
8).
L The ringer volume is turned off. Adjust the ringer
volume (page 10, 11).
L The handset is not turned on. Turn the power on
(page 5).