Advertisement
6 Things You Should Know
6-A Battery
Recharge
When the RECHARGE indicator flashes or the unit beeps
intermittently, place the handset on the base unit for about
9 hours to recharge the battery.
RECHARGE
Indicator
Battery information
After your Panasonic battery is fully charged:
Operation
Operating time
While in use (TALK)
Up to about 7 hours
While not in use (Standby)
Up to about 120 hours
• The battery operating time may be shortened depending on usage
conditions and ambient temperature.
• As preventative maintenance, clean the handset and the base unit
charge contacts with a soft, dry cloth once a month. Clean more
often if the unit is subject to grease, dust or humidity. Otherwise
the battery may not charge properly.
• If the battery is fully charged, you do not have to place the handset on
the base unit until the RECHARGE indicator flashes. This will maximise
the battery life.
• The battery cannot be overcharged.
Battery replacement:
If you cleaned the charge contacts and fully charged the
battery, but after a few telephone calls, the RECHARGE
indicator flashes, the battery needs to be replaced. Replace the
battery with a new Panasonic P-P301 (KX-A36A) battery. See
section 1-C, step 3. When replacing the battery, programmed
information may be erased. Reprogram if necessary.
To replace the battery:
Press the notch on the cover firmly and slide it as indicated by
the arrow. Replace the old battery with new one (1-C). Close the
cover and charge for about 9 hours.
N
6-B Wall Mounting
This unit can be mounted on a wall.
1
Press the tabs in the direction of the arrows (1), then remove
the wall/desk stand (2).
1
2
Connect the AC adaptor. Tuck the telephone line cord inside
the wall/desk stand, then push it in the direction of the arrows
(1 and 2).
• The word "UP WALL" should face upward.
3
Connect the telephone line cord. Install screws using the wall
template below. Mount the unit, then slide down.
• Extend the antenna fully.
• Fasten the cords to prevent it from being disconnected.
Wall Template
5 cm
N
6-C Base Unit Location
Calls are transmitted between the base unit and the handset
using wireless radio waves. For maximum distance and noise-
free operation, we recommend the following:
Away from electrical appliances
such as a TV, radio or
personal computer.
2
1
Extend
fully.
To Power
Outlet
2
1
6-D Specifications
Base unit
Power Supply:
Power Consumption:
Frequency:
Dimensions (H x W x D):
Mass (Weight):
Hooks
Handset
Screws (not included)
Power Supply:
Frequency:
Dimensions (H x W x D): Approx. 260 mm x 55 mm x 45 mm
5 cm
Mass (Weight):
Security Codes:
Operating Environment:
Specifications are subject to change without notice.
For Australia
To Telephone Plug
and Socket
OR
For New Zealand
To Single-Line
Telephone Jack
N
In a HIGH and CENTRAL
location with no obstructions
such as walls.
AC Adaptor (230 – 240 V AC,
50/60 Hz)
Standby:
Approx. 5 W
Maximum: Approx. 7 W
30 MHz – 39 MHz
Approx. 90 mm x 125 mm x 210 mm
Approx. 260 g
Ni-Cd battery (3.6 V, 300 mAh)
30 MHz – 39 MHz
Approx. 170 g
1,000,000
5 °C – 40 °C
Hide quick links:
Advertisement
