Using Your Air Conditioner; Electronic Control Panel & Remote Control; Normal Operating Sounds - Soleus Air WM1-06E-01 Operating Instructions Manual

USING YOUR AIR CONDITIONER

Electronic Control Panel & Remote Control
Note: This control panel display always shows the room
temperature in Fan Mode except when setting the tem-
perature and timer.
COOL
DRY
FAN
AUTO
MODE
MODE
TEMP/TIME

Normal Operating Sounds

x
You may hear a pinging noise caused by water
hitting the condenser on rainy days, or when the
humidity is high. This design feature helps re-
move moisture and improve efficiency.
x
You may hear the thermostat click when the
compressor cycles on and off.
x
Water will collect in the base pan during rain or
days of high humidity. The water may overflow
and drip from the outside part of the unit.
x
The fan may run even when the compressor is
not on.
1. Power Button: Turn the air conditioner on and
off.
2. Digital Display: Will display set temperature
when the unit is in Cool ,Dry, Auto, Sleep, Energy
Saver mode, and display current room tempera-
ture when in Fan mode.
3. Temperature Set: Use these buttons on the con-
trol panel or remote to increase or decrease the
Set Temperature.
SLEEP
MODE
ENERGY
HIGH
SAVER
CHECK
MED
FILTER
TIMER
LOW
ON/OFF
DELAY TIMER
SPEED
FILTER RESET TEMP/TIME
POWER
4. Timer Set: Use these buttons on the control
panel and remote control to set the timer. Each
press of the▲or▼ button will increase or de-
crease the timer. For timer instructions see #7.
5. Fan Speed: Use the fan speed button to change
the fan speed. Choose between high, medium,
and low.
6. Mode Button: Press the MODE button to cycle
through the various modes: Auto, Sleep, Energy
7. Auto-on Timer: When the air conditioner is off, it
can be set to automatically turn on in 1-24 hours
at the previous set mode and fan settings. To set
the Auto-on Timer, press the DELAY TIMER but-
ton on the unit or remote control. Timer can be
set in 1 hour increment.
Auto-off Timer: When the air conditioner is on, it
can be set to automatically turn off in 1-24 hours.
To set the Auto-off Timer, press the DELAY
TIMER button on the unit or remote control.
Timer can be set in 1 hour increment.
Once timer is set, TIMER ON/OFF indicator on
control panel will light up, the set temperature will
also shown on digital display.
x
To see the remaining time, press DELAY TIMER
button. To change the timer settings, use the
▲or▼ on control panel or remote control.
x
During preview of timer setting, press DELAY
TIMER button once to display set time, press the
button one more time to cancel the settings.
8. Filter Reset: After the fan rotates for 250 total
hours, the filter check light will turn on to remind
the user to clean the filter. Press the FILTER RE-
SET button to reset the reminder once the filter is
cleaned.
9. Signal Receiver: Point the remote control to the
air conditioner when sending instruction to the
unit.
10