Mitsubishi D700 VFD Installation Manual page 12

12 | P a g e
Test Run
You can test your spindle motor directly from your VFD. Follow the sequence below.
1. Press PU/EXT to put the VFD into PU mode (make sure the PU LED is on).
2. Press the Mode button until the MON LED turns on.
3. Turn the wheel to set your frequency and press Set. The screen will flash between F and your frequency.
4. Press Run and the motor should begin moving.
5. Press Stop/Reset to stop the motor.
If it seems to be running well, you should continue by setting up Mach3. Make sure to exit PU mode!