How It Works; Extracting For Nutriblast Rx's - NUTRIBULLET Rx User Manual

HOW IT WORKS

* Do not run SouperBlast Mode with any of the blending cups. Only use the
vented SouperBlast Pitcher. Read all safety instructions fi rst!

EXTRACTING FOR NUTRIBLAST Rx'S

1
Add ingredients into one of the cups.
2
Fill with liquid up to the Max Line. Then, twist the
Extractor Blade onto the cup and tighten by hand to
make sure the vessel is sealed.
3
Plug the power base into an electrical outlet. Press
the power button, located 90˚ to the left side of the
G-button, to turn the machine on. The power button
light will glow BLUE, signifying power. Next, place
the cup blade-side-down onto the power base. This
will activate the NutriBullet Rx's SMART Technology
function, causing the G-Button at the front of the
unit to glow GREEN, and initiating the 1-minute
extraction cycle.
4
When the cycle has completed and the
light has turned off, turn off the unit by depressing
the power button, located 90˚ to the left side of
the G-button . The BLUE light will stop glowing,
signifying the power is off.
14
MAX
LINE
GREEN
POWER BUTTON
Note: You can remove the cup at any time during the blending cycle by simply
lifting the cup off of the Power Base. If more extraction is required, lift the
cup off of the Power Base, wait 15 seconds, then return it back onto the
Power Base to start another SMART Technology cycle. Do not repeat more
than 3 consecutive cycles resting 15 seconds between cycles. If you press
the green G-button for 2 seconds and the light turns RED, you have switched
in SouperBlast Mode. Simply lift the cup off the Power Base at any time to
exit this mode or press the power button, located 90˚ to the left side of the
G-button. When the vessel is removed from the power base, only the G-button
light will turn off. When the power off button is pressed, the
off and the blade will stop spinning. Always press the power off button upon
completion of processing .
• NOTE: IF AT ANY TIME THE G BUTTON IS PUSHED FOR 2 SECONDS, THE BUTTON
WILL TURN RED AND INITIATE SOUPERBLAST MODE.
• WHEN EXTRACTING OIL BASED OR STICKY FOODS, REFER TO INSTRUCTIONS
LISTED UNDER TAP TECHNIQUE ON PAGE 19.
• DO NOT TOUCH COUPLING GEAR DIRECTLY WITH HANDS AFTER NUTRIBLAST
MODE! THE COUPLING GEAR IN BLADE BASE AND POWER BASE WILL BE HOT!
• TO TURN OFF THE MACHINE AT ANYTIME DURING THE NUTRIBLAST CYCLE (G
BUTTON WILL BE GREEN), PRESS THE POWER BUTTON, LOCATED 90˚ TO THE
LEFT SIDE OF THE G-BUTTON OR LIFT THE CUP OFF THE POWER BASE.
BLUE light will turn
15