Honda 2005 CR-V Owner's Manual page 70

High Beams Push the lever
−
forward until you hear a click to turn
on the high beams. The blue high
beam indicator will come on (see
page ). Pull the lever back to
59
return to the low beams.
To flash the high beams, pull the
lever back lightly, then release it.
The high beams will stay on as long
as you hold the lever back.
Daytime Running Lights
Canadian models only
With the headlight switch off, the
high beam headlights and the high
beam indicator come on with
reduced brightness when you turn
the ignition switch to ON (II) and
release the parking brake. They
remain on until you turn the ignition
switch off, even if you set the
parking brake.
The headlights revert to normal
operation when you turn the switch
to the '' '' position.
Headlights, Instrument Panel Brightness, Hazard Warning Button
Instrument Panel Brightness
INSTRUMENT PANEL BRIGHTNESS
CONTROL KNOB
Turn the knob on the left side of the
instrument panel to adjust the
brightness of the instrument panel
lights.
Hazard Warning Button
Push the button below the center
vents to turn on the hazard warning
lights (four-way flashers). This
causes all four outside turn signals
and both turn indicators in the
instrument panel to flash. Use the
hazard warning lights if you need to
park in a dangerous area near heavy
traffic, or if your vehicle is disabled.
67