Table of Contents
Advertisement
As next select in the column Coupling the input coupling of the channel. You have the choise between:
Coupling
Zero
Differential Ended DC
Differential Ended 3Hz High Pass Filter
The column Resistor enables the selection of the ½-bridge and ¼-bridge complement resistor. This selection is
not needed in case of a full bridge.
In the column „Shunt" a shunt resistor with 100kΩ can be switched on, to unbalance the bridge with a defined
value.
Description
Input+ and Input- will be shorten to channel ground.
The output signal is 0V.
The differential signal between Input + und Input – will
be amplified and outputted.
As „Differential Ended DC", but the signal will be
filtered by a 3Hz high pass. No DC components of the
measurement signal will be outputted.
Operation Manual Version 1.6
5. Channel setup
36
Advertisement
Table of Contents
