Optional Unit Installation; Ut-124 Installation; Ut-108 Installation - Icom IC-F43TR Instruction Manual

Hide thumbs Also See for IC-F43TR:

Table of Contents

OPTIONAL UNIT INSTALLATION

Install the optional UT-124

q Rotate [VOL] to turn the power OFF, and remove the bat-

tery pack. (p. 1)

w Remove the unit cover.

NOTE: Use a ﬂat head screw driver or a similar ﬂat instrument,

and insert into the hollow of the chassis, then lift and take away

the unit cover. (The removed cover cannot be used again.)

e Install the unit as shown below.

r Replace the unit cover and the battery pack, then rotate

[VOL] to turn the power ON.

as follows:

MAN DOWN UNIT

Install the optional UT-108

DTMF DECODER UNIT

q Rotate [VOL] to turn the power OFF, and remove the bat-

tery pack. (p. 1)

w Remove the unit cover as shown at left.

e Cut and solder the pattern on the PCB at the RX AF cir-

cuit as shown below.

r Install the UT-108

DTMF DECODER UNIT

scribed in the optional UT-124 installation as shown at left.

t Replace the unit cover and the battery pack, then rotate

[VOL] to turn the power ON.

NOTE: Be sure to un-solder A and B, and re-solder B

and C, otherwise no AF output is available when you

remove the DTMF decoder unit.

as follows:

the same way as de-

Table of Contents