Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for GT POWER GT3500SE
Summary of Contents for GT POWER GT3500SE
- Page 1 GT3500SE...
-
Page 2: Table Of Contents
GT3500SE Contents Introduction..........3 Environmental Protection......3 Scope of Product........3 Description of Symbols......3 Specifications........3 Safety Information........4 Features & Controls.........7 Control Functions........8 Preparation before Operating....10 Operating the Generator......12 Maintenance.........16 Storage...........20 Troubleshooting........21 Parameters........22 Electrical Diagram........23 Calculating Your Power Needs .....24 Warranty..........25 www.gtpower.co.nz... -
Page 3: Introduction
GT3500SE Introduction Description Of Symbols Your new GT POWER Generator will more than satisfy your expectations. It has been The rating plate on your tool may show sym- manufactured under stringent quality stand- bols. These represent important information ards to meet superior performance criteria. -
Page 4: Safety Information
GT3500SE Safety Information • NEVER operate this product inside any building, carport, porch, mobile equipment, marine applications, or enclosure, even if Read this manual carefully and become windows and doors are open. familiar with your generator. Know its applications, its limitations and any WARNING: Starter cord kickback hazards involved. - Page 5 GT3500SE When Starting Equipment • Use a ground fault circuit interrupter in any damp or highly conductive area, such as • Ensure spark plug, muffler, fuel cap and metal decking or steel work. air cleaner are in place. • DO NOT touch bare wires or receptacles.
- Page 6 GT3500SE When Adjusting or Making NOTE: Improper treatment of generator could damage it and Repairs to the Generator shorten its life. • Disconnect the spark plug wire from • Use generator only for intended uses. the spark plug and place the wire where it •...
-
Page 7: Features & Controls
GT3500SE Features and Controls Read this Operating Manual and the Safety Rules section before operating your generator. Compare the illustrations with your generator, to familiarise yourself with the locations of various controls and adjustments. Save this manual for future reference. -
Page 8: Control Functions
GT3500SE Control Functions results mean better fuel consumption and less noise. When the ESC switch is turned to “OFF”, the engine runs at the rated (3100 3 in 1 Switch Knob r/min) Regardless of whether is a load con- 1. Engine/Fuel Valve OFF means the nected or not. - Page 9 GT3500SE flickers for a few seconds, the engine oil is insufficient. Add oil and restart. Overload Indicator Light (Red) The overload indicator light comes on when an overload of a connected electrical device is detected, the inverter control unit over- heats, or the AC output voltage rises.
-
Page 10: Preparation Before Operating
DC protector turns off. If the DC protector turns off again, stop using device immediately and consult your nearest GT POWER Dealer. Preparation before Operating NOTE: Pre-operation checks should Ground (Earth) Terminal be made each time before operating. -
Page 11: Adding Fuel
GT3500SE Adding Fuel Adding Engine Oil • Fuel is highly flammable and poisonous. The generator has been shipped without Check SAFETY INFORMATION on pgs engine oil. 4 - 6 carefully before filling. WARNING: Do not start the engine • Do not overfill the fuel tank, otherwise it till filled with the sufficient engine oil. -
Page 12: Operating The Generator
GT3500SE Operating the Generator WARNING: Never operate the engine in a closed area or it may cause unconsciousness and death within a short time. Operate the engine in a well ventilated area. The generator has been shipped without engine oil. -
Page 13: Stopping The Engine
GT3500SE 1. Turn off and disconnect any electrical When starting the engine, with the ESC “ON” devices. and there is no load on the generator: In 2. Turn the ESC to “OFF” (1). ambient temperature (below 0 C ), the engine will run at the rated (3600r/min) for 5 mins to 3. -
Page 14: Battery Charging
(red) may come on. It is normal for this to go POSITIONS. off within four seconds If the overload indicator (red) stays on, consult your GT POWER The DC protector turns off automatically if dealer. current above the rated flows during battery charging. -
Page 15: Ac Parallel Operation
1. Connect the parallel operation cable may shorten the service life of the between the GT3500SE to another generator. GT3500SE with the optional Parallel Link Limit operation requiring maximum Kit. power to 30 minutes. 2. Start the engines and make sure the output... -
Page 16: Maintenance
GT3500SE NOTE: Do not overload. The total Every 12 Months or 300 Hours: load of all electrical appliances must not exceed the supply range of the Check, clean & replace where necessary: generator.Overloading will damage • Fuel filter the generator. - Page 17 GT3500SE • Check the cleanliness of the generator frequently and clean when dust, dirt, oil, moisture or other foreign substances are visible on its exterior surface. CAUTION: Never insert any object or tool through the air cooling slots, even if the engine is not running.
-
Page 18: Carburetor Adjustment
GT3500SE Carburetor Adjustment Engine Oil Replacement The carburetor is a vital part of the engine. Avoid draining the engine oil immediately Adjusting should be left to a dealer with the after stopping the engine. The oil is hot and professional knowledge and specialised should be handled with care to avoid burns. -
Page 19: Air Filter
GT3500SE 4. Add oil to the foam element and squeeze out excess oil. The foam element should be wet but not dripping. 5. Insert the foam element into the air filter case. 8. Add oil till to a suitable level tighten oil filler cap. -
Page 20: Storage
GT3500SE Muffler Screen WARNING: Never use an engine without an appropriate spark arrester WARNING: The engine and muffler will in forest areas! Doing so may cause be very hot after the engine has been a fire! run. Avoid touching the engine and muf-... -
Page 21: Troubleshooting
• Faulty ignition system - Consult a GT Power Service Dealer - www.gtpower.co.nz Generator Won’t Produce Power • Safety device (DC protector) to “OFF” - Press the DC protector to “ON”. -
Page 22: Parameters
GT3500SE Parameters Model No. GT3500SE Generator Type Inverter Rated frequency /Hz Rated voltage /V Max. output power /KVA Rated output power /KVA Power factor ISO8528 G2 AC output quality ≤5 Generator THD/% Noise Level dB/LpA/LwA/K 4m (3/4 load) 12-8 DC Output/ V-A... -
Page 23: Electrical Diagram
GT3500SE Electrical Diagram 230V / 50Hz www.gtpower.co.nz... -
Page 24: Calculating Your Power Needs
GT3500SE Calculating Your Power Needs Firstly add up all the “running wattage” requirements for all items that you need to power simultane- ously. Next, add to that total the highest of the “starting wattages” you listed down. Now you know approximately how much power you need to start and run your appliances and equipment. -
Page 25: Warranty
WARRANTY: Repair or replace, at Warrantor’s option, repair or replace, at no charge for parts or labour, the GT POWER Generator, if proven defective in material products or components which have failed within or workmanship, during the following time period(s) duration of the warranty period. - Page 26 GT3500SE www.gtpower.co.nz...
- Page 27 GT3500SE www.gtpower.co.nz...
- Page 28 Congratulations on your new GT POWER product. We are proud to have you as our customer and will strive to provide you with the best service and reliability in the industry. This product is backed by our extensive warranty and world-wide service network. To locate your nearest distributor or service agency...
Need help?
Do you have a question about the GT3500SE and is the answer not in the manual?
Questions and answers