Advertisement
6. Install the wire harness (P/N 50TG400620). The motor
plug should be located at the actuator side of the unit and
enough slack left on the motor end so that the plug can be
disconnected for easy service if required. Route the wires
Fig. 1 — Return End of Unit
Fig. 2 — Frame Support Brackets
(Side Panel Removed)
RETURN END
OF UNIT
Fig. 3 — Slide Economizer Assembly into Unit
FRAME
SUPPORT
BRACKETS
(SIDE PANEL
REMOVED)
WIRE
TIES
PLASTIC
BUSHING
2
through the plastic bushing, being careful not to damage
the wires. Route the harness across the back of the top
member of the frame as shown and attach to the frame us-
ing the wire ties provided. (See Fig. 4.)
Fig. 4 — Wire Routing
WIRE ROUTING
PLASTIC BUSHING
(EXISTING)
Advertisement
