Vax performance V-091 Instruction Manual page 3

2. Safety Information
FOR HOUSEHOLD USE ONLY
When using the vacuum cleaner, basic safety
precautions should always be observed, including
the following:
1. Only use the vacuum cleaner indoors on dry
surfaces.
2. Turn off the vacuum cleaner controls before
connecting or disconnecting from the mains
supply.
3. Always unplug the vacuum cleaner before
connecting or disconnecting the vacuum hose
and accessories.
4. This appliance is not intended for use by young or
infirm persons unless they have been adequately
supervised by a responsible person to ensure
that they can use the appliance safely.
Young children should be supervised to ensure
that they do not play with the appliance.
5. Use only as described in this manual. Use only
the manufacturer's recommended attachments.
6. Do not use the vacuum cleaner if it has been
dropped, damaged, left outdoors or dropped
into water. Do not use the vacuum cleaner with
a damaged cord or plug. If the supply cord or
plug is damaged, return the vacuum cleaner to
a Vax Authorised Service Agent for examination,
repair or adjustment.
7. Do not pull or carry by the cord. Do not use the
cord as a handle, close a door on the cord or
pull the cord around sharp edges or corners. Do
not run the vacuum cleaner over the cord. Keep
the cord away from heated surfaces.
8. Do not handle the plug or vacuum cleaner with
wet hands. Do not use outdoors or on wet
surfaces or to vacuum up fluids.
9. Do not put any objects into openings. Do not use
with any openings blocked and do not restrict air
flow. Keep all openings free of dust, lint, hair or
anything that may reduce airflow.
10. Keep hair, loose clothing, fingers and all parts
of the body away from openings and moving
parts.
11. Do not pick up hot coals, cigarette butts, matches
or any hot, smoking or burning objects.
12. Do not pick up flammable or combustible
materials (lighter fluid, petrol, kerosene, etc)
or use in the presence of explosive liquids or
vapours.
13. Do not vacuum up harmful or toxic material
(chlorine bleach, ammonia, drain cleaner, etc).
14. Do not vacuum up hard or sharp objects such
as glass, nails, screws, coins, etc.
4
V-091 performance user guide.ind3 3
15. Do not use without the filters in place.
16. Take extra care when vacuuming on stairs.
17. Keep vacuuming area well lit.
18. Store the vacuum cleaner indoors in a cool, dry
area.
19. Turn off the on/off switch before unplugging the
vacuum cleaner.
20. Use only approved extension cords. Non-
approved extension cords may overheat. Care
should be taken to arrange the cord so that the
cord cannot be pulled or tripped over.
WARNING: Always switch off and unplug the vacuum
cleaner from the electrical outlet before assembling,
opening or emptying the dirt container, or before
connecting/disconnecting the attachments.
CAUTION: The vacuum cleaner is a very powerful
unit. Before plugging the cord into the electrical
outlet, make sure the switch is in the 'off' position.
Hold the vacuum cleaner firmly when starting and
in use.
IMPORTANT: If the inlet, hose or telescopic tube is
blocked, switch off the vacuum cleaner and remove
the blockage(s) before re-starting the vacuum
cleaner.
IMPORTANT: Regular washing and cleaning of
filters improves vacuum performance. Make sure all
the filters are completely dry before inserting back
into the vacuum cleaner.
This vacuum cleaner is intended for household use
only and not for commercial or industrial use.
Motor Thermostat
IMPORTANT: The motor is equipped with a thermal
cut-out. If for any reason, the vacuum cleaner should
over-heat, the thermostat will automatically turn
the unit off. Should this occur, unplug the vacuum
cleaner from the electrical outlet and turn the unit
off. Remove the dirt container and empty. Clean the
filters. Allow the cleaner to cool for approximately
one (1) hour. To re-start, plug into an electrical outlet
and switch back on.
Replacement Filters
Replacement filters are available from your Vax
stockist or Vax direct. Phone Vaxcare or visit:
www.vax.com.au
3. How to Assemble
IMPORTANT: Always unplug the vacuum cleaner
from the electrical outlet before assembling or
removing the accessories.
1. Insert the flexible hose into the inlet on the main
body of the vacuum cleaner. Push in until it clicks
into position (Fig.3/1).
2. Push the telescopic extension tube on to the end
of the handle (Fig.3/2).
3. The telescopic extension tube can be lengthened
or shortened by pushing the button in and sliding
the tube apart or together as required (Fig.3/3).
4. Fit the combination floor head by pushing onto
the extension tube (Fig.3/4).
4. How to Operate
Cord Release
Fully unwind the power cord. A yellow mark on
the power cord indicates the recommended
cord length. DO NOT EXTEND THE CORD
BEYOND THIS MARK.
On/off Button
1. Insert the power plug into the electrical outlet.
Make sure the vacuum cleaner is switched off.
2. Press the on/off switch, located on the top of the
vacuum cleaner, to switch on the vacuum cleaner
and press the button again to turn the vacuum
cleaner off.
Carpet Cleaning
For carpet and rug cleaning, press the rocker switch
on the combination floor head to raise the brushes.
Hard Floor Cleaning
For hard floor cleaning, press the rocker switch on
the combination floor head to lower the brushes.
Cord Rewind
To rewind the power cord, press the cord
rewind button, located on the top of the vacuum
cleaner, and guide the power cord with one
hand. Rewind 1-1 / metres of cord at a time.
1
2
This will prevent the cord from whipping which
could cause damage or injury.
Variable Power
Located between the on/off and cord rewind buttons
there is a variable power dial. Slide this clockwise
and anti-clockwise to adjust the suction power. The
5-stage indicator lights suggest the suction power
for common tasks.
Carry Handle
Lift the carry handle located at the rear end of the
vacuum cleaner to move from room to room. Do not
pick vacuum cleaner up by dirt container handle.
Hose Storage
For convenience there is a slot located on either
side of the vacuum cleaner where the floor tool and
hose can be parked for carrying and storage.
5. Accessories
1. The accessories can be attached directly to the
handle by removing the telescopic tubes and
pushing in the desired accessory.
2. The accessories can also be attached to the
telescopic extension tube for extra reach.
Remove the combination floor head and push on
the desired accessory.
Crevice tool: for crevices, corners and cracks, etc.
Dusting brush: for delicate surfaces.
Upholstery tool: for carpet, upholstery, stairs, etc.
19/4/06 12:10:26 PM
5