Connections - Panasonic SC-PM10 Operating Instructions Manual

1
For Europe
2
For Europe
1
AM loop antenna
3
Black ( )
3
L
R
Black ( )
6
RQT6682
1
2
3
To household
mains socket
For Others
FM indoor
antenna
1
For Others
1
2
2
Red ( )
1
2
Red tag
Silver (
Red ( )

Connections

• Plug the AC mains lead into a household mains socket
only after all other connections have been made.
• To prepare the AM loop antenna wire and speaker cords,
twist the vinyl cover tip and pull off.
1
Connect the FM indoor antenna.
Tape the antenna to a wall or column, in a position
where radio signals are received with the least amount
of interference.
Note
For the best reception:
An FM outdoor antenna is recommended. (\ page 7)
2
Connect the AM loop antenna.
After attaching the antenna, turn on the system and
tune in a broadcast station. Put the antenna where the
reception is best and interference is minimal.
3
Connect the speaker cables.
Connect the speaker cords without tags to the black
terminals, so (+) and (–) are correct.
Connect the speaker cords with red tags to the red
terminals, so (+) and (–) are correct.
2
Never allow the exposed wires to contact each other
when connected.
Incorrect connection can damage the unit.
Caution
Use only the supplied speakers.
The combination of the main unit and speakers provide
the best sound. Using other speakers can damage the
unit and sound quality will be negatively affected.
Caution
• Use the speakers only with the recommended
system.
Failure to do so may lead to damage to the
amplifier and/or the speakers, and may result
in the risk of fire. Consult a qualified service
person if damage has occurred or if you
experience a sudden change in performance.
• Do not attach these speakers to walls or
ceilings.
4
Connect the AC mains lead.
FOR THE UNITED KINGDOM ONLY
READ THE CAUTION FOR THE AC MAINS
LEAD ON PAGE 4 BEFORE CONNECTION.
Insertion of Connector
Even when the connector is perfectly inserted,
depending on the type of inlet used, the front part of the
Copper connector may jut out as shown in the drawing.
( )
However there is no problem using the unit.
Appliance inlet
)
Note
The included AC mains lead is for use with this unit
only. Do not use it with other equipment.
Connector
Approx. 3.5 mm