Nera saturn bp Technical Manual page 34

Replacing Trunk Parts
13
• Remove the clamps pressing the IC against the cooling plate
(Note! Save the Sil pads
• Remove the screws fastening the RF Unit cover.
Note! 3 screws - 2 sizes (M3x16 / M4x10). See figure!
• Remove the screws fastening the Main Control Board.
Note! 2 screws – M4x6. See figure!
The Main Control Board may now be replaced.
DISMOUNTING
M3x16 M3x16
M4x6
M4x10
2 2
2
• Fasten the Main Control Board.
Note! 2 screws – M4x6. See figure!
• Mount the RF Unit cover.
Carefully tighten the screws evenly.
Note! 3 screws - 2 sizes (M3x16 / M4x10). See figure!
• Replace the clamps
Note! Insert a sufficient amount of Sil pads so as to
avoid tension on the IC.
32
14
Replacing the DSP PROM
Tools required:
• PLCC extractor
• Wrist strap
• Follow the instructions in steps 1 – 8 of the dismounting
procedure.
• Locate the DSP PROM
• Place the PLCC extractor diagonally over the PROM as
shown in the figure.
• Carefully pull up the PROM from the socket.
DISMOUNTING
clamps
M4x6
PLCC Extractor
MOUNTING
1 1
1
IMPORTANT!
Use wrist strap when handling the new PROM!
• Align the PROM correctly and push it carefully down into
the socket.
DISMOUNTING
DSP PROM
MOUNTING
S e r v i c e S e r v i c e S e r v i c e
PROM
Extraction of DSP PROM
MOUNTING
Saturn Bp Portable – Technical Manual