Table of Contents
Advertisement
Edge Jointing
The purpose of edge jointing is to produce a
finished, flat-edged surface that is suitable for
joinery or finishing, as shown in Figures 42–43.
It is also a necessary step when squaring rough
or warped stock.
Figure 42. Example of edge jointing operation.
Removed
Surface
Figure 43. Illustration of edge jointing results.
-30-
To edge joint on jointer:
1.
Inspect stock to ensure it is safe and suitable
for the operation (see Stock Inspection &
Requirements section).
2.
Set infeed table height to desired cutting
depth for each pass.
IMPORTANT: For safety reasons, cutting
depth should never exceed
3.
Set fence to 90˚.
4.
Start jointer.
5.
Place workpiece firmly against fence and
infeed table.
IMPORTANT: To ensure workpiece remains
stable during cut, concave sides of workpiece
must face toward table and fence.
6.
Feed workpiece completely across cutter-
head while keeping it firmly against fence
and tables during the entire cut.
IMPORTANT: Keep hands at least 4" away
from cutterhead during the entire cut. Instead
of allowing a hand to pass directly over cut-
terhead, lift it up and over cutterhead, and
safely reposition it on the outfeed side to con-
tinue supporting workpiece. Use push blocks
whenever practical to further reduce risk of
accidental hand contact with cutterhead.
7.
Repeat Step 6 until the entire edge is flat.
Tip: When squaring up stock, cut opposite
edge of workpiece with a table saw instead
of the jointer—otherwise, both edges of work-
piece will not be parallel with each other.
Model G0490W/G0490XW (Mfd. Since 5/16)
⁄
" per pass.
1
8
Advertisement
Table of Contents
