Installing The Wire Spool - Eastwood flux core 90 Assembly & Operating Instructions

FI .
G C
INSTALLING THE WIRE
SPOOL
The Eastwood Flux Core 90 can be used with a 4 inch wire spool only. To install the wire spool
follow the procedure listed below:
1. Open the door of the welder and remove the wing nut (FIG. C-C1) and spacer from the
Wire Spool Spindle.
2. Slide the 4 inch Wire Spool onto the Wire Spindle and reinstall the spacer and wing nut.
To order parts and supplies: 800.345.1178 >> eastwood.com
C4
C1
C2
C3
11