CONTENTS Safety information Care and cleaning Safety instructions Troubleshooting Operation Installation Daily Use Noises Hints and tips Technical information Subject to change without notice. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages.
Do not use mechanical devices or other means to accelerate • the defrosting process, other than those recommended by the manufacturer. Do not damage the refrigerant circuit. • Do not use electrical appliances inside the food storage • compartments of the appliance, unless they are of the type recommended by the manufacturer.
Page 4
electrician to change the electrical • Do not freeze again food that has been components. thawed. • The mains cable must stay below the • Obey the storage instructions on the level of the mains plug. packaging of frozen food. •...
OPERATION Switching on 1. Turn the Temperature regulator toward lower settings to obtain the minimum 1. Insert the plug into the wall socket. coldness. 2. Turn the Temperature regulator 2. Turn the Temperature regulator toward clockwise to a medium setting. higher settings to obtain the maximum coldness.
depending on the time available for this To make these adjustments gradually pull operation. the shelf in the direction of the arrows until it comes free, then reposition as required. Small pieces may even be cooked still frozen, directly from the freezer: in this Temperature indicator case, cooking will take longer.
Frozen Food Calendar The symbols show different types of frozen goods. The numbers indicate storage times in months for the appropriate types of frozen goods. Whether the upper or lower value of the indicated storage time is valid depends on the quality of the foods and treating before freezing.
• the maximum quantity of food which can compartment, can possibly cause the be frozen in 24 hrs. is shown on the skin to be freeze burnt; rating plate; • it is advisable to show the freezing in • the freezing process takes 24 hours. No date on each individual pack to enable further food to be frozen should be you to keep tab of the storage time.
This operation will improve the A certain amount of frost will always form performance of the appliance and save on the freezer shelves and around the top electricity consumption. compartment. Defrost the freezer when the frost layer Defrosting of the refrigerator reaches a thickness of about 3-5 mm.
TROUBLESHOOTING WARNING! Refer to Safety chapters. What to do if... Problem Possible cause Solution The appliance does not oper- The appliance is switched Switch on the appliance. ate. off. The mains plug is not con- Connect the mains plug to the nected to the mains socket mains socket correctly.
Problem Possible cause Solution The temperature in the appli- The temperature regulator Set a higher/lower temperature. ance is too low/too high. is not set correctly. The door is not closed cor- Refer to "Closing the door". rectly. The food products' tem- Let the food products tempera- perature is too high.
Page 12
Some functional problems might CAUTION! Refer to the occur for some types of models assembly instructions for the when operating outside of that installation. range. The correct operation Door reversibility can only be guaranteed within the specified temperature range. 1. Loosen and remove the upper pin. If you have any doubts regarding where to install the appliance, please turn to the...
Page 13
8. Install the lower door. 9. Tighten the middle hinge. 10. Install the spacer. 2. Install the appliance in the niche. 11. Install the upper door. 3. Push the appliance in the direction of 12. Tighten the upper pin. the arrows (1) until the upper gap cover Do a final check to make sure stops against the kitchen furniture.
Page 14
Make sure that the clearance between the appliance and the cupboard is 4 6. Open the door. Put the lower hinge cover in position. 4 mm 9. Attach the covers (C, D) to the lugs and the hinge holes. 44 mm 7.
Page 15
19. Open the appliance door and the kitchen furniture door at an angle of 14. Tighten the screws of the part (G) again. 90°. 15. Attach the part (H) to the part (G). 20. Insert the small square (Hb) into guide 16.
25. Press the part (Hd) on the part (Hb). 8 mm 23. Place the small square on the guide again and fix it with the screws Do a final check to make sure that: supplied. • All screws are tightened. 24.
TECHNICAL INFORMATION Technical data Dimensions of the recess Height 1780 Width Depth Rising time Hours Voltage Volts 230 - 240 Frequency The technical information are situated in the rating plate, on the external or internal side of the appliance and in the energy label. ENVIRONMENT CONCERNS dispose appliances marked with the symbol Recycle the materials with the symbol...
Need help?
Do you have a question about the C7280FP and is the answer not in the manual?
Questions and answers