Power Up And Standby - Raymarine T300 Operation And Setup Manual

3.3 Power up and standby

When the breaker connecting power to the camera is switched on,
the camera will run a boot up sequence lasting for about 1 minute,
after which the camera will be in Standby mode.
In order for the camera to operate, you must bring the camera out
of standby mode using the camera controls.
Thermal camera standby
Standby mode can be used to temporarily suspend the thermal
camera's functions when the camera is not needed for a prolonged
period.
When in standby mode the camera:
• Does NOT provide a live video image.
• Moves the camera into its "stowed" (parked) position (lens facing
down into the camera base) to protect the camera optics.
• Engages its pan / tilt motors to hold the camera in place in rough
seas.
Note: The "stowed" (parked) position can be configured using the
camera's setup menu.
Power menu
Menu item / Description Settings / Operation
Assign JCU Assigns the JCU to the camera.
JCU Stndby? This option places the JCU in standby. The camera
and other controllers on the system are unaffected.
Camera Stndby? With this option the camera moves to its stow
position and enters standby mode. The JCU
remains on and available to "wake" the camera.
22
Menu item / Description Settings / Operation
System Off This option places both the JCU and camera into
Standby mode.
Calibrate JCU Use the "Calibrate JCU" function to calibrate the
JCU puck.
Follow the on screen instructions to calibrate the
puck:
• Rotate CCW / CW – requires you to rotate the
puck fully clockwise, then counter-clockwise.
then press the puck to continue.
Exit the Power Menu.
Cancel
T-Series thermal cameras – Operation and setup