Table of Contents
Advertisement
WPIM location guidelines for outdoor gate applications:
•
Mount the WPIM indoors, within the secured portion of the premises.
•
Install the WPIM just inside the building's outer wall that faces the gate.
•
If the WRI-OTD(s) to be controlled by this WPIM are outdoors, use the remote WPIM
antenna option. Mount the Remote Antenna Module outside of the building, in direct line-of-
sight to the WRI-OTD(s) that it controls.
•
Never install the WPIM in an all metal room or a room with wire screening/mesh in the walls,
without the remote WPIM antenna option located outside that room.
•
If a site uses more than one WRI-OTD, install the WPIM within direct sight of both WRI-
OTDs under its control, and never more than 1000 feet away from either using the internal
WRI-OTD and WPIM antennae. Refer to section 2.3, above, to increase this range using
external remote antennae. Use a separate WPIM for each WRI-OTD if the site geometry
makes this necessary.
•
When using the standard WPIM antenna, mount the WPIM 6 feet or more from the floor.
WRI-OTD Location Guidelines for outdoor gate applications:
•
Mount the WRI-OTD within the secured portion of the premises, in direct line-of-sight to the
WPIM's antenna.
•
Orient the WRI-OTD upright, preferably on the side of the gate closest (facing) the WPIM.
•
Avoid obstructions between the WRI-OTD antenna and WPIM antenna.
2.3.2 Elevator Applications
Note: These elevator applications deal only with access control portion and not elevator control. The
WRI-OTD has not been evaluated to UL508.
245 W. Roosevelt Road, Bldg 7, Suite 48, West Chicago, IL 60185 / (800) 313-2962 / (630) 293-4257 fax
P/N: M053-003-C
Figure 2-1 – Outdoor Gate Installation
Ingersoll Rand Security Technologies
www.ir-swa.com
Wireless Access
Page 7 of 20
Advertisement
Table of Contents
