Page 1
With sincere apology for that the following items have been left off the previously issued Service Manual (No. 20824) for the XL-R5000BK, we issue this supplement to add those items to the Service Manual. 1. CD-R unit's tray and belt replacement procedure 2.
Page 2
XL-R5000BK CDR Unit Tray Replacement Procedure Refer to the separate figure. When removing the tray: 1. Make sure that the pickup is located in the innermost position (usual position). If the pickup is out of the innermost position, locate it in the innermost position with care not to touch the lens.
Page 3
XL-R5000BK CRD-Unit Belt Replacement Procedure Refer to the figure below. 1. Remove the tray following to the tray removal procedure. 2. Remove the belt with the tweezers or the like. 3. Wipe over the belt creep ( in the figure) of the pulley gear (...
Page 4
XL-R5000BK How to check for 3CD and CD-R 1. Special tools and CDR & CDRW Disc. CD TEST DISC:CTS-1000 CD-R for Audio CD-RW for Audio Note: 1. Be sure to use general audio CD-R and CD-RW disks available on the market for this set.
When this menu item is executed, the RID code is read out and it is shown by the FL tube for 5 seconds. This selection is automatically cleared after the 5-second display. Example of display: JVCCA01089231 Manufacturer code: JVC Type code: CA01 Unique No.: 089231 2.
XL-R5000BK Check mode Method 1. Check Mode The Check Mode is prepared for checking timer operation and display with the FL tube. 2. Check mode setup method Setup: In the status that the set is turned off, press the POWER key together with the DISPLAY key to turn on the set.
Page 8
XL-R5000BK VICTOR COMPANY OF JAPAN, LIMITED AUDIO & COMMUNICATION BUSINESS DIVISION PERSONAL & MOBILE NETWORK B.U 10-1,1Chome,Ohwatari-machi,Maebashi-city,371-8543,Japan Printed in Japan No.20824B 200008(O)