Alignment Procedure; Method For Entering Factory Mode; Factory Service Menu Index - TCL SY33 Service Manual

3、Alignment Procedure
Method for Entering Factory Mode：
a. Production mode: Press the key [Fac] in remote control to enter or exit factory mode(But only
display 4 pages);
b. Engineer mode: Press key [DISPLAY] to display channel information（Setup for display picture
on bottom left of screen, press the number key [6][1][5][8] ;
c. Display "--PRODUCT--" ，then press the key [MUTE] two times，the factory menu on the screen 。
The number on top right corner of factory menu is page number of factory menu. Press the key
[CH+/-] to adjust curser up or down。Press the key [VOL+/-] to change the value。When choose
the first top line, press [VOL+] / [VOL-] to choose the menu page。
d. Press key [sleep] to display factory menu in production mode. Please choose next page when display
factory menu。
e. Press key [0] to be shifted to one bright line status in production mode,. Press key [0] again to return factory
menu.
Relevant key number for one bright line：
[1] RB+
[4] RB-

Factory Service Menu Index:

*** PAGE 1 ******
V.POSITION/50
V.POS SHIFT/50
V.SIZE/50
V.LIN/50
V.SC
OSD-V-START/50
OSD-H-POS
CHANGE PRO.
*** PAGE 1 ******
V.POSITION/60
V.POS SHIFT/60
V.SIZE/60
V.LIN/60
V.SC
OSD V.START/60
OSD-H-POS
CHANGE PRO.
*** PAGE 2 ******
H.PHASE/50
[2] GB+ [3] BB+
[5] GB- [6] BB-
Init Range
19 0...63
0 0...15
79 0...127
23 0...31
17 0...31
0 0...3
20 0...127
Init Range
19 0...63
0 0...15
79 0...127
23 0...31
17 0...31
0 0...3
20 0...127
Init Range
15 0...31