General - Panasonic C9701U Operating Instructions Manual

General

This chapter explains how to turn on or off the power, how to adjust the volume, etc.
Power on
Press [SRC] (PWR: Power).
Notes:
¡ The opening screen appears. You can overwrite the
opening screen (moving picture) with new one.
page 40)
¡ When the power is switched on for the first time, a
demonstration message appears on the display. Press
[DISP] to change to regular mode.
Power off
Hold down [SRC] (PWR: Power) for 2 sec.
or more.
Note: The ending screen appears. You can overwrite the
ending screen (moving picture) with new one.
40)
You can remove the face
plate to prevent it from
being stolen.
Removing
1
Turn off the power. (a page 14)
2
Press [ ] (Release).
(The face plate disen-
gages with a click when
it is removed.)
The face plate automati-
cally closes in 5 sec-
onds if it is open or tilt-
ed.
The power is automatically turned off while the unit
is active.
Cautions:
¡ It is recommended to remove or mount the face
plate when the plate is at the closed position.
Do not remove or mount the face plate when the
plate is in motion.
¡ This face plate is not waterproof. Do not expose it to
water or excessive moisture.
¡ Do not remove the face plate while driving your car.
¡ Do not place the face plate on the dashboard or
nearby areas where the temperature rises to high
levels.
14
CQ-C9901U/C9801U/C9701U
CS
SRC SRC
(a
(a page 12)
(a page
3
Put the face plate in the case.
Mounting
1
Slide the left side of the face plate in
place.
2
Press the right end of the face plate
until "click" is heard.
¡ Do not touch the contacts on the face plate or on the
main unit, since this may result in poor electrical
contacts.
¡ If dirt or other foreign substances get on the con-
tacts, wipe them off with clean and dry cloth.
¡ To avoid damaging the face plate, do not push it
down or place objects on it while it is open.
Open/Eject
Press [ ] (OPEN).
When a disc is already loaded, the disc will automatically
be ejected.
Cautions:
¡ To avoid damaging the face plate, do not push it
down or place objects on it while it is open.
¡ Do not pinch your finger or hand in the face plate.
¡ Do not insert foreign objects into the disc slots.
¡ For the following cases, the face plate automatical-
ly closes. Use caution not to catch your finger.
¡ After a lapse of 20 seconds
¡ When a disc is inserted
¡ When the face plate is removed (a page 14)
Close
Press [ ] (OPEN).
q Up
w Down
Setting Range: 0 to 40
Default: 18
Volume off (down)
Press [ ](MUTE).
Cancel
Press [ ](MUTE) again.
Note: Volume-down range can be specified. (a page
38)
CQ-C9901U/C9801U/C9701U
CS
SRC
Tilt
The display angle changes among 4 levels as follows
every time you hold down [ ] (TILT) for 1 sec. or
more and release.
Note: The last selected
TILT 1
angle is maintained even
TILT 2
TILT 3
after turning off the power.
OPEN
TILT OFF
Notes:
¡ The volume level can be set independently for each
source. (For radio, one volume setting for AM, one
volume setting for all FMs)
¡ The volume is not adjustable while an error display is
on the monitor. (a page 46)
SRC CS
15